Rack Battery Parallel Expansion & Addressing

Rack batteries are modular: start with the modules you need today, add more when the site grows, and never rebuild the bank from scratch. That is the whole point of a parallel rack bank — capacity grows one module at a time. But new 51.2V modules only join the bank if the addressing is right: every module needs its own DIP address, exactly one module acts as the CAN master, and the cluster stays within its module limit. Get any of those wrong and the new modules sit unrecognized, the master reports the wrong capacity, or the bank stops sharing current evenly. This page covers rack-module parallel expansion only — DIP addressing, master-slave CAN setup and the cluster limit — and ends with the checklist to send LJY Energy before ordering. General parallel-battery theory is covered on our low-voltage bank expansion page.

LJY Energy is a LiFePO4 supplier and OEM/ODM coordinator in Shenzhen; we are not a factory. We supply 19-inch 51.2V rack battery modules only, not UPS units, racks or PDUs.

19-inch rack battery modules stacked in a server rack
Photo: Abigor, Wikimedia Commons, CC BY-SA 3.0 (resized, WebP). Illustrative image, not an LJY product.

Rack module data

CellsLiFePO4, 16S × 3.2 V
Nominal voltage51.2 V
Module options100 Ah · 5.12 kWh · 3U / 200 Ah · 10.24 kWh · 4U
Max. continuous current (100 Ah module)100 A
Operating voltage range44.8–57.6 V
CommunicationCAN, RS485, RS232
Modules in parallel (max.)16
Charge temperature0–50 °C
Discharge temperature−20–55 °C

Source: LJY 51.2V rack module page.

Expansion example

An integrator starts with 4 100 Ah modules holding 20.48 kWh, then the site needs double the runtime. Instead of replacing the bank, they add 4 more modules — each set to the next free DIP address, slaves numbered after the master — taking it to 8 modules and 40.96 kWh, with one master and 7 slaves on the same CAN bus. The original modules stay in service; nothing is thrown away. The 16-module cluster limit still leaves room for a second expansion later; beyond 16 modules the bank needs a master/hub layout, confirmed per project.

What to send before a proposal

  • Modules installed now, with their DIP addresses and which one is the master
  • UPS or inverter model and its CAN protocol version
  • Target runtime or total kWh after expansion
  • Free rack space in U and the DC cable lengths in the cabinet

Request a sizing

Send the module count and addresses in use, the UPS or inverter model, and the runtime you need after expansion. LJY Energy will confirm the module count, the DIP address plan and the master-slave CAN setup, then quote the expansion with delivery terms. We coordinate OEM/ODM battery supply from Shenzhen; we are not a factory, and every order is confirmed in writing before production.

LiFePO4 rack battery bank with CAN master-slave addressing
Photo: VGrigas (WMF), Wikimedia Commons, CC BY-SA 3.0 (resized, WebP). Illustrative image, not an LJY product.

Request a rack battery sizing · WhatsApp +86 159 8945 0735