Battery not on Victron’s compatibility list: what to check

Victron publishes a battery compatibility page that names batteries known to have been tested with its products, mostly connected over BMS-Can to a GX device. Installers are often offered a battery that is not on that list. Anyone searching for a battery not on Victron’s compatibility list wants to know whether it can still be used, what Victron itself says, and what to confirm before the purchase.

LJY Energy is a LiFePO4 supplier and OEM/ODM coordinator in Shenzhen, not a factory. Our batteries are not on Victron’s tested list, and we do not claim they are. Victron’s page states that other third-party batteries may be used under warranty with support from a local supplier, and that Victron shares its battery protocol specification with battery makers on request. Any pairing with a Victron system is confirmed per project.

Victron Quattro inverter/charger installed on a wall, a common GX system component
Photo: Asurnipal, Wikimedia Commons, CC BY-SA 4.0 (resized, WebP). Illustration, not an LJY product.

Request a test unit review for a Victron system · WhatsApp +86 159 8945 0735

What Victron’s page says, and what to confirm

Point from Victron’s pageWhy it mattersBuyer checklist
Tested list of named batteriesVictron-tested combinationsis the exact battery model listed? if not, who supports it
Other batteries permitted with local supplier supportwarranty and support pathnamed local support contact in writing
BMS should lower the charge voltage limit (CVL) near fulllimiting only current can cause alarmsconfirm CVL behaviour in the BMS documentation and on test
Battery must have its own disconnect, such as a contactordigital signals alone are not enoughconfirm the disconnect device in the battery datasheet
LJY inverter communication guidedocumented settingsreference only, not a verdict

Victron also describes problems seen with DIY BMS units that set charge current to zero when full: overload or overcharge warnings that disappear on the test bench. These points are checked on a test before a project is rolled out.

What to send before ordering

  • GX device model and firmware version.
  • Inverter/charger model (for example a Quattro or MultiPlus) and firmware.
  • Battery BMS protocol and the documentation of its CVL and CCL behaviour.
  • Battery disconnect design and rating.
  • Who provides local support for the battery.

Test first, then repeat

Installers who bench-test one battery with their GX setup, record the settings and only then roll it out avoid alarm troubleshooting on site. Prices and lead times only in a quotation.

Second view of a Victron Quattro inverter/charger in a home installation
Photo: Asurnipal, Wikimedia Commons, CC BY-SA 4.0 (resized, WebP). Illustration, not an LJY product.

How we proceed

Victron system data and firmware → BMS documentation review → test unit → project decision. No compatibility verdict is published in advance.

Send your Victron system details and request a review

LJY Energy, Jack Lai. Unit 705, Building 1, Lecai Industrial Park, 10 Kaijing Road, Longtian Street, Pingshan District, Shenzhen 518122, China. +86 159 8945 0735.